All I wanted was a little more light in the dining room so I gathered up the curtain in one hand and pulled it up and discovered … an Angel Curtain Treatment!

[Please excuse my unwashed window. We’ve pared back on a lot of things since my surgery. ;) ]

Normally, the sheer curtain just hangs over a tension rod stuck in the window frame. I don’t hang the curtain full length as normal, using the rod through the curtain sleeve, but rather just drape the floor-length panel over the tension rod so the pretty embroidered bottom edge hangs about halfway up the window as seen in this fall photo.
I also like the double thickness of the sheer when I hang the curtain like that.

To make the angel curtain treatment, all you need are two S hooks with lengths of ribbon tied on and whatever decoration you want to use for the top of the “angel head.” That’s it! One end of the ribbon is shorter than the other when tied, as you can see here.

I made two S hooks from an old hanger, making sure they would fit over the tension curtain rod. I like using the inner stiffening layer from men’s ties as ribbon. (You can see what else I used the tie pieces for here.) In this tutorial, I will call the wool tie interlining pieces “ribbons” for clarity.

The curtain is very light and airy and you can see how long it is here. I’m not sure this treatment would work as easily with a heavier curtain. Also, the top of the curtain will actually be the bottom of the angel’s dress. So the back of the curtain’s hemmed sleeve must look good.

To begin making the angel, the S hooks with ribbons were hung near the center of the rod.

The two shorter ends of the ribbons were tied loosely across the middle, wrapped several times to make the ends hang at the sides of the “angel head.” I didn’t have to tie any knots because the rough tie fabric held position easily when wrapped around several times. But if your ribbon is slick, like satin, you will have to pin it together to make it stay.

Here I’m lightly gathering the curtain in one hand, a little above the embroidered edge. I adjusted the curtain length over the rod and made sure the embroidered edge was arranged with pretty folds as I gathered it together.

Once the curtain was gathered together in my hand, I raised it up.

Again, I adjusted the folds to adjust the bottom of the curtain.

Once the curtain was held up, I looped the long left ribbon under and around the bundle of gathered curtain.

The two long long lengths of ribbon tie were tied together under the gathered bundle.

I fine tuned the embroidered curtain edge, pulling it down a bit to make it longer.

Here you can see the curtain sleeve from the top of the curtain now hanging at the bottom of the angel’s dress.

To finish the angel, I simply tucked a small halo of gold star holiday wire and a Christmas package decoration on top of the ribbon tie.

The finished Angel Curtain Treatment

To make this window treatment took less than 5 minutes. Seriously, it took longer to rummage through my old ribbon box to find the package decoration! To take it down, simply untie the ribbon from behind the curtain and remove the S hooks. Super simple.

And Thank You, Brenda, for your husband’s ties. This project finished up the linings I had from the first batch of ties. Your bag of ties will be plenty for new projects!